If you are in the same scenario, we totally understand the stress.

Thermal/ Moisture Protection Estimating 》Ĭommercial electrical contractors are always under high work pressure and concerned about tight budgets and short deadlines.

* All images including but not limited to render pictures, animations, user interface on this page are for demonstration purposes only and may differ from actual product. Be sure to abide by local laws and regulations when using the product. * Before using the product, please carefully read the Xiaomi Electric Scooter 4 Pro user manual and legal notice. Actual results may vary based on differences in use conditions. * All data and statistics, unless otherwise stated, were obtained from Ninebot labs. The result indicates that with five holes, the tire pressure only fall under 25psi after 1,700km of riding the scooter. Then ride the scooter on concrete road, measure the tire pressure after every 500km, if the tire pressure is less than 25psi, pump the tire to 45psi.

* Self-sealing tire road test: puncture the tire with five 3mm holes, set the tire pressure to 45psi. Test conducted by Wuxi I-Reach Technology Co., Ltd. After pullin the nails out, no air leakage was detected. * Self-sealing tire static test: tire pressure set at 3.0Bar, hammer 3 nails with 4mm in diameter into the tire with a depth of 35±5mm, no air leakage is detected. The scooter must move at a speed of 6km/h or more when exiting the slope. * 20% incline climbing ability test condition: 70% or more battery and a vehicle load of 75kg, with the scooter moving at 15km/h before entering a slope of 20% with a length of 10 meters.

* Maximum speed may vary by country depending on local regulations.

* 25km/h max speed: tested with 50% or more battery. * 55km travel range test condition: battery fully charged and a vehicle load of 75kg, with the scooter moving at a constant speed at 60% of the max speed on a flat road until the vehicle speed was significantly reduced such that it could not move, measured range was over 55km.

Home designer pro electrical take off